I bought Original TOP2011 USB Universal Programmer (as shown bellow picture), it failed to work with Chip programmer Socket PSOP44, because of incompatible pin.
In this article you may find same and difference between these models F01, W01, W02, F02, W03 and S5 .And you will know how to choose them and make full use.
How to change mileage for Toyota Camry with Digimaster 3? Please follow the instructions as follows.
Here’s all about original Autel MaxiSys MS906 diagnostic tool for more than 80 car makes in the market.
Please kindly check the error message” Device Internal Error”. This message pops up when I launch VVDI MB tool software while my VVDI is connected.
This is TOYOTA TIS Techstream 10.30.029 update and installation guide. Tis v10.30.029 has been successfully on mini vci (for 22pin), new mini vci, xhorse mvci, mangoose, vxdiag vcx nano for toyota.
Lucky to get the cheapest SKP-900 key programmer for $599($60 saved).
And did copy Edge smart key this morning.
It means KESS V2 can’t read and write this type of ECU, ECUs on the same car model in different areas are sometimes encrypted in different ways, and therefore the tool cannot always work on the same car model.
I replaced chip and reset tokens, then get connection error “External exception EEFFACE” as following picture shows.
Here’s the new information for the skp900 4.1 version key programmer for $619.
AK500+ Problem: after use AK500+ key programmer to read out MCU data in the EIS, I input EIS data into SKC calculator to alternate key data, and then write the key data into key. Then I can start up the vehicle, no remote control.
www.uobd2.net engineer tell you how to setup Volvo Vida Dice 2013D and use it to diagnose.
Hello help me please I did buy the Tuirel s777 the sn number is 680130013xxx the machine was working without update software when did I try to update the card …