March 2020 – Page 2 – UOBDII Official Blog

Where to Get Star Diagnostic with the Engineer/Developer Mode?

March 10, 2020 uobdii 0

Where I should purchase a star diagnostic that will allow me to do the engineer/developer mode. My main reason to use this right now is to attach the SBC pump fix.

Touareg 3.0 tdi v6 EDC 16CP34 ECU programmers reviews

March 10, 2020 uobdii 0

Car model and ECU type: Touareg 3.0 tdi v6 EDC 16CP34 Purpose: Read and write ECU ECU programmers using experience: @km666 review: Audi,VW EDC16CP34 reading […]

hextag-ecu-read-write-function-via-tricore-07

Hextag ECU Read/Write Function Using Tricore Power Module

March 9, 2020 uobdii 0

HexTag Programmer can read the ECU’s D-flash and P-flash in fraction of seconds which is faster compared to any tool in the market.

Mitsubishi-Pajero-2016-Key-Programming-by-Autel-IM608-1

Mitsubishi Pajero 2016 Key Programming by Autel IM608 Programmer

March 8, 2020 uobdii 0

In this instruction i will show you guide on how to use Autel MaxiIM608 programmer to program key for Mitsubishi Pajero sport 2016+.

Comparison:Xhorse smart remote, super remote, wired remote, wireless remote

March 7, 2020 uobdii 0

Look at the comparison table among Xhorse wired remote, wireless remote, super remote, smart remote (comprehensive made by Xhorse chief engineer).

How to renew Benz ECU with VVDI MB & CGDI MB?

March 6, 2020 uobdii 0

Confirmed: both VVDI MB & CGDI MB can renew Mercedes Benz ECU. This article is available with the step-by-step procedure.

Nissan Consult 3 plus Infiniti Q50 Feedback

March 5, 2020 uobdii 0

Nissan consult 3 plus diagnostic tool is confirmed to cover Infiniti Q50 (i.e New Infiniti Q50 Y37 07/2017 – Onwards), seeing is believing, please look at the following two images.

Read-write-bosch-edc17c74-with-ktag-7-020-05

Confirmed: Ktag7.020 Read Write Bosch EDC17C74 Possible

March 4, 2020 uobdii 0

Question: I try to read Bosch EDC17C74 with Red PCB ktag7.020 Ksuite 2.25 and higher voltage but no success. Confirmed: I can read write […]

How to fix ktag MPC555 “Communication error with the ECU”?

March 3, 2020 uobdii 0

Look at the following images, I used ktag master Ksuite software to read & write MPC555, I got ” Communication error with the ECU: control all connections.