CGDI MB Program Benz Sprinter Key Tutorials

Here is the tutorials about how to use CGDI MB program Mercedes Benz Sprinter key.

Device:

CGDI Prog MB Key Programmer

CGDI MB Be Key

Original car key

Vehicle:

2013 Mercedes Benz Sprinter

Prepare work:

Connected the CGDI MB programmer to the laptop via USB cable, and connected to the OBD port of the vehicle via main cable (on the left- hand side near the fuse box)

Open the computer to run CGDI MB software

Step by Step:

Read the EIS

Go to EIS- EZS>> Read EIS Data to read out the original data and save it

Get the password

Go to Compute password and follow the steps on the screen to do

Select copy key with key>> collect data>> select other keys

Insert the original key into the EIS and click OK (don’t turn it on)

Remove the original key and put it into the coil of CGDI MB device

That’s collected the data from the original key

Then insert the key back into the EIS

Just follow the instructions on the screen at all times

  • Pull out the key from theEIS, and then insert it again
  • Pull out the key for 5 seconds and insert again
  • Insert the key into the CGDI MB key programmer

After the connection is done, save the file

Then upload the data to calculate the password

When the process is successful, click the query result button to query the password

The password is calculated, it’s in the box.

So what we do now is to copy the password and paste it to the related position on EIS interface.

After that, save the file

Generate key file

Go to pick V051 and my key slot so on this vehicle, then load the EIS file to generate the key file

Save the key file just generated

Read/write key

Plug the new key into the CGDI MB device to read data

From the screen, we can see the new key has not been used, it’s got no SSID and it’s been allocated not a position. There is no position being allocated to that key. So that’s fine.

Then go to open the file and select the key file has just generated to write automatically.

After the key is written successfully, go to read the key again, now it’s got SSID and it’s been put into position. So the key should start the vehicle now.

Put the key into the EIS and wait 5~10 seconds for the key to activate

It can start the vehicle. Press lock and unlock button of the key, both work fine.

Insert the original key to start the car, still works normally.

Done.

Share