How to Enable IMMO and Programming in Consult ?

Here is how to Enable IMMO and Programming in Consult 3 plus without spending out on the smart card.

Consult-3 Plus

Find the consult diagnostictool.ini file
open with notepad
copy and paste this at the bottom

 

Here for Consult 3 plus:

C:\CONSULT-III_plus\System\Application\ApplicationData\CommonSetting\DiagnosticTool.ini

 

Instruction:

[current_geographical_zones]
market=2
area=3
country=USA
[current_language]
language=GB
[unit_conversion]
unit_conv_1=G001.S002
unit_conv_2=G002.S004
unit_conv_3=G003.S006
unit_conv_4=G004.S009
[current_channel]
channel=0

[system_management]
access_mode=1

[device]
vi_device_name=J-Box
[vehicles]
tab_index=2

[mode]
debug_mode=TRUE
debug_mode_vehicle_battery=TRUE
[vehicles]
tab_index=0
This is working on my setup
Copy this into your diag.inx folder change the region area and J2534 name and you should be good to go .

 

Question and answer:

Is the Consult 3+ working a 100% with J2534?
Do I need any extra files or media to download to be able to program?

 

Answer:  You are pretty limited using a Pass-Thru with Consult software I believe. Read and Delete fault codes yes. Programming and Security I think not. Best to use a Consult3 or 3+ interface. You can program using Nissan Ners software with a Pass-Thru though.

 

For the files, You will need to buy access on Nissan website for the flash files. I think you can buy a 4 hour access but you must check this. It varies depending on Country and how Nissan are feeling it seems. Diagnostic software can be found on the forum.

Share