Here is tutorials of Calibrate Xhorse Dolphin XP-008 Key Cutting Machine, Only need four steps.
Step by step:
Step 1. Install the calibration plate
Turn off the power of Dolphin XP008
Loose the clamp
Take the calibration rod out and stick it into the spindle pin hole
Loose the lock screw with a wrench
Remove the cutter
Install the calibration plate and lock screw
Step 2. Lateral adjustment of Micro-adjust base
To start with
Make sure the main and auxiliary clamps stay inside A and both locked
Rotate the handwheel till the calibration plate touches the rightmost position of the auxiliary clamp
Then slightly loosen the fixing screw of the sliding base
Use an Allen wrench to slowly adjust the left adjusting screw until the key cutting guide touches the rightmost position of the auxiliary clamp as well
Tighten the fixing screw after the adjustment
Step 3. Vertical adjustment of Micro-adjust base
Stick the calibration rod into the clamps and tighten the clamp
Make the rod stick close to the XP008 key cutting guide and the plate simultaneously
You can adjust the knob of the micro-adjust base to make sure that there’s mo resilience between the key cutting guide and the rod.
Step 4. Height adjustment of Micro-adjust base
Height adjustment is usually finished before the Dolphin XP008 leaves the factory.
Rotate the handle to adjust the angle of the rotation table to ensure that the key cutting guide and the plate contact the rod simultaneously during the rotation.