Cut RAV4 2018 keyless with Xhorse Dolphin XP005L

Question: Ref blade for Xhorse Dolphin XP005L for cut ? RAV4 2018 keyless.

Look at the images below:

The key to cut, and the Xhorse Dolphin XP005L, the key reader and VVDI Key Tool Plus I have.


Much easier to put the key into the side cut section of the jig and cuts perfectly.

New Xhorse clamp M5.

Exactly depending on which version you have.

Ours has an area just above where the key is secured.

If your M5 champ is able to grip the key the same as though it was an edge cut key.

This is exactly how we use Ours.

Also make sure that you choose 4 cuts. For some reason they default to 5 cut

Just make sure it is tightened good and keep a keen eye so it doesn’t slip out

But how do we get them?

use this “TOY40” M5 clamp.

Someone advised “Need the little shim under the key blank and cuts fine” (shown as the following image):

And someone advised “ I usually put a Honda tumbler under works great“.

Hona tumblers is exactly the same thickness.

yep It’s super quick on the 3d extreme or Elite love those laser products. Just preorder the condor gen 2 let’s see how that one handles

However, this shim is not working on the new X5 clamp, Xhorse Dolphin XP005L comes with new Xhorse clamp M5.