Can Autel IM508 + XP400 Pro add smart key to Jaguar f-pace 2018 via OBD?

Problem:  

Autel IM508 + XP400 Pro can’t add a smart key to the Jaguar f-pace 2018,can not decode vin and manually also does not work on obd, I already upload the data to Autel server.

Reply:

Autel IM508 + XP400 Pro can add smart key for this car via dump instead of OBD, please dismantle the KVM module to do.

For this car Jaguar f-pace, it is 2018, please confirm if the RFA is FK72 or HPLA.

Please refer to the following guide on Range Rover 2018 AKL by using Autel MaxiIM IM608 and XP400 and APA106 (dump mode), for APA106 adapter, it is contained in the package.

(Note: If you encounter any type of problem during the process, please upload the datalog on the top-right corner after failing to perform the functions. Please connect your device to the network while performing the following functions.)

Specific add key(all key lost) procedure is as follows:

RFA(also called KVM) module located (shown as below), remove the module and remove the case.

De-solder the crystal and the capacitor.

Solder the lines

T1 and T2 are the components of capacitor and crystal.

After you have connected the MCU to the programmer XP400 with APA106 cable, click on the go to “Read chip status”à Read/Write chip data(secure)(read chip from MCU)à Start key writingà Read/Write chip data(secure)(write new data back to MCU)

Select the Dflash and EEPROM file that you have saved, Then choose a blank key position ID to make the dealer key.

Then go back to the menu Read/write chip Data to write the new created Dflash file and EEPROM file back to the MCU.

Writing key successfully!

Learn more: https://www.uobdii.com/wholesale/autel-maxiim-im508-plus-xp400-pro.html

Share