This post will guide you how to use KEYDIY SPC560B60L3 Chip Programming Socket and KD-X4 key programmer to write initialization data for Jaguar/Land Rover KVM/RFA Module without soldering.
Operation guide:
Step 1: Place chip
Put a new SPC560B60L3 chip and align it in KEYDIY Programming Socket correctly.
Match the “Pin 1” indicator on the socket with Pin 1 on the chip.
Gently place the chip into the socket.
Step 2: Close lid
Close the socket lid securely after the chip is seated properly.
Step 3: Connect to KD-X4
Plug the socket into KEYDIY KD-X4 via the pre-connected OTG cable
Step 4: Write Initialization Data
Navigate to Immo programming menu on KD-X4 tablet
Select KD-X4/KD Prog mini → Write File → Write JTAG (SPCXXXX) Chip → RFA Write Initialization Data-> J9C3-RFA_SECURE (SPC560B60L3)
Write initialization data until the process is completed
Step 5: Reinstall chip
Remove the chip from KEYDIY SPC560B60L3 programming socket.
Solder the chip onto the circuit board as usual.
Install the circuit board back into the vehicle for next operations
