Reflashed with VAS5054 clone using ODIS-E 11.0.0 all OK


I tried flashing (update) yesterday a A6 4F 3.0TDI Quattro 2005 tiptronic gearbox TCU with ODIS Engineering 11.0.0 using VAS 6154 and resulted the error “Flashen der Datenblöcke fehlgeschlagen.”

Now, PRNDS disappeared from the cluster’s display and gearbox lever is stuck in P.


I was using VAS 6154 with Windows 10 Pro X64.
ODIS Service 5.1.6 and ODIS Engineering 11.0.0 works just fine (DTC, coding, etc.), the only problem seems flashing.

Tried flashing with USB connection as well as WiFi connection, no success.
I even lowered the Baud Rate down to 100 kbit, as well with no success.


The conclusion is:

The VAS6154 or VXDIAG can only Read DTC,CODING.

Flashing with ODIS-E dont´t work with this TOOL.

You can Repair or Reflash this with good VAS5054 org or Clone Tool on Win7 or with older Versions 100% work, have Reflash the Dashboard on A6 4F 3.0 2006 today.

You can try new Installtion with Windows7 on Virtul Maschine and Choose the VAS5054A in Launcher when you install this.

Best Solution at Moment VAS5054a with good OKI or Used org VAS6154.



you can try this,  install and download virtual machine. In forum I have seen WIN7 Image with ODIS+Enginerring.

If you have install this, download the VX Manager this is the driver for the clone cables.  The Cable what we have is in the end a clone from VAS5054a.



So what are you telling me to do is use the VAS6154 as an VAS5054 on Windows 7 with ODIS-E to see if it works flashing ?
Do you think the Windows 10 is the problem ?


Windows is not the Problem, the Cable VAS6154 is same function as the normal VAS5054a. There are too little Information about this for end user who buy this.
Try this on Win7 and choose as Interface the 5054a.



I cannot use VAS6154 as VAS5054.

I ended up buying a VAS5054 clone. Better VAS5054 on Win7.

I reflashed with VAS5054 clone using ODIS-E 11.0.0 on Win7 X64 and all is ok now.


Look at VAS5054 clone with OKI Chip:

VAS5054-clone-pcb-01 VAS5054-clone-pcb-02