XENTRY Diagnosis VCI (C6) XENTRY XDOS V3.0.1.508 update info & guide, and if you use your own Xentry software you need to configure by following our tutorial.
1.Vxdiag Benz C6 Xentry V3.0.1.508 update info:
1). Release XENTRY Diagnosis VCI (C6) driver and the compatible software XENTRY XDOS 2018.05
2). Release XENTRY Diagnosis VCI (C6) driver for XENTRY XDOS 2018.05
2.XENTRY XDOSV3.0.1.508 update guide:
1.Upgrade newest VCX firmware version 1.4.4.0.
2.Upgrade newestDoIP firmware version 1.3.1.
3.Setup BENZ C6 driver
You need:
XENTRY Diagnosis VCI (C6) + XENTRY XDOS V3.0.1.508:
Reason: VCI + Xentry software, you can directly use after receive the package.
3.Vxdiag Benz C6 XENTRY XDOSV3.0.1.508 configuration:
* If you use your own Xentry software you need to configure by following our tutorial.
Remark: If the XENTRY XDOS V3.0.1.508 is setup automatically, you are required to configure the Xentry Diagnosis VCI by following the bellow procedure.
- configure the Xentry Diagnosis VCI, select ” XENTRY Diagnosis VCI”
- Click on “Configure”.
- Click on “Continue”.
- Click on “Continue”.
- The “StartKey” is not found, click on “Manually” to enter “StartKey”.
- Save key and click on “Application and Continue”.
- Click on “Application and continue”.
- Configuration complete, click on “Exit”.
9.Configuration complete, reboot the PC.
Configuration succeed and the XENTRY Diagnosis VCI is connected ok, then this icon below will display.