The BMW FRM2/FRM3 module can be fixed in many ways,here UOBDII show these ways to repair BMW FRM2/FRM3.Hope it helps!
Here UOBD2 share the new XProg-M V5.84 ECU software on Win7.Hope this article is helpful to your work!
XPROG-M is a kind of ECU programmer tool which can be supported on BMW ECU Cas4 with software version V5.74, there are some using suggestions and FAQ about XPROG-M V5.74 may help you.
V5.84 Xprog M ECU programmer with USB dongle is successfully installed on WIN7 64bit without activation and able to read and write more devices than V5.74.
Newest XPROG-M V5.84 adds some more authorization than XPROG-M V5.74, meanwhile it can’t support most of EEPROM brand 8oin chip that V5.74 supports.
The latest V5.70 XPROG-M updates released and available, the customer can get 5.70 Xprog-m ECU programmer on uobdii.com
Finally Xprog M V5.7.0 universal ECU programmer is tested fine to read write ECU with new authorization (see details as below), and newly released at uobdii.com, price only 139USD+shipping cost.
This post starts with XPROM V5.60 ECU programmer using tips, and then follows with XPROG-M V5.60 setup procedures.
Are you still confused about which tool to read and write Motorola 5M48H? Or do you want more details for that? Here uobdii.com engineer will advise you choose
Several days ago when I used XPROG-M V5.55 to read BMW E46 M35080 EEPROM, I got error ”FF”, the interface of error shown below:…
I’m try to find some cheap tool for decoding (make to virgin) Fiat Stilo IAW 5NF.T9 Marelli ECU. I don’t want to pull the PCB out, don’t want to drill a hole and…
Some users asked whats the best eeprom programmer in the market. In the following parts, uobd2.net senior engineer list some best-selling and good quality eeprom programmers.
Here, you will know all TM100 functions for BMW, including special functions like key programming, reading data of BMW airbag/dashboard/immo…
If your Xprog-M V5.50 or V5.48 get any of the following errors, including: machine is dead, xprog-m can read but fail to save, or get “Unknown command, Software error”…