SEC-E9 is a powerful key cutting machine,it not only support auto key cutting,but also can cut for house key.And there i show the guide on how to use SEC-E9 to cut Silca HU100 key.
Power on SEC-E9 machine,and press “Search” button.
Enter “HU100”,then press “Search” button,select “SILCA”
Press menu button,and press “info” button to know the basic information.
This key is guided by “Tip”
Then close the window
Press “decode” to enter the decoding page
Click the image of three-terminal positioning and press “Round off”
Check if the original key can work well
Fix the original key on car key clamp
Please note the key should be fixed level.
Press “decode”,and click the picture of “Clean the groove from chips” to start decoding.
Take away the original key
Fix a HON66 key blank on car key clamp.
Please not the key blank should be fixed level
Click “cut” button to enter cutting page
Press “Speed” and “Normal resolution” button.
Click the image of three-terminal positioning
You can adjust the cutting depth,usually it is 1mm.
Press “Cut” button to start cutting.Please remember to close the safe gate.
Cutting is done.
Open the safe gate.Clean the clamp,and take out the new key.
Change the other side of the key blank on the car key clamp for cutting,click “cut” button and close the safe gate.
Cutting is done,open the safe gate and take out the new key.
Try your new key if the new key works.
UOBDII Official Blog All rights reserved SEC-E9 Key Cutting Machine Test on Cutting Silca HU100 Key